AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |
Back to Blog
Allwinner H3 Datasheet4/9/2021
The configurations for the triggerhappy utility are stored in the etctriggerhappytriggers.dexample.conf file.By applying some simple configurations it will work as a router.
The following cards are what we used in all our test cases presented here. On the utilitys main window select your TF cards drive, the wanted image file and click on write to start flashing the TF card. In practice, this means that you can have all the features you need with none of the bloat, powered by a modern Linux kernel. Allwinner H3 Datasheet Serial Communication BoardAfter you connect your board to a serial communication board you will be able to do development work from a commandline utility. Here is a hardware setup: After you connect your board to a serial communication board (e.g. FriendlyElecs serial communication board) you can power the whole system from either the DC port on the serial communication board or the MicroUSB port(if there is one) on your board: or you can use a USB to serial board and power on the whole system at the MicroUSB port with a 5V2A power: By default you will login as root without a password. On first boot the system will automatically extend the file system on the TF card to the max capacity: Please wait for this to be done. Before power on your board make sure your board is connected to a master routers LAN with an Ethernet cable and the eth0 will be assigned an IP address by DHCP. After you go through all the steps in and get an IP address e.g. Ethernet connection, type this IP address in a browsers address bar and you will be able to login OpenWrt-LuCI: By default you will login as root without a password, just click on Login to login. Each cores temperature is 26.5 degrees in Celsius, the scheduling policy is on-demand and the working frequency is 624MHz. Each cores temperature is 26.5 degrees. Each cores governor is on demand and the frequency is 480 MHz. All collectd-mod- packages use the same configuration file: etcconfiglucistatistics. You can connect your smart phone to it and browse the internet. If this LED doesnt blink it means the system is dead and it needs to be restarted. If WAN works this LED will be solid on otherwise it will be off. You can check the Transmit Receive box to set the LED to blink when WAN transmits receives data. If LAN works this LED will be solid on otherwise it will be off. You can check the Transmit Receive box to set the LED to blink when LAN transmits receives data. By default when BUTTON is pressed a reboot will be triggered. If the system needs to be rebooted we suggest you use BUTTON to trigger a reboot. This prevents the file system from being damaged by accidental system shutdown.
0 Comments
Read More
Leave a Reply. |